Posts

Chosen Solution Everything started a while ago (I think) I had an original lightning cable for over 4 years, I used it to charge everything, including the 5S, at some point, this cable stopped charging on one side, but on the other it still worked! The problem now is that I need to connect the iPhone to my computer and it doesn’t gets recognised. Yesterday I replaced the lightning port with a new one, but still does nothing, I need help, please :(...

Chosen Solution My phone has this problem where after around a 5 or so minutes it just shuts off. I have tried a DFU reset. I can see battery heath. I have no idea where to look A bad charging port can cause your phone to turn off after 3 minutes. If you buy another make sure its a genuine part as some aftermarket ones have required sensors missing causing more problems....

Chosen Solution I was working on my laptop in the night and i shut it down. I turned off the charger but left all accessories attached including a second screen which was also turned off. But in the morning it didn’t turn on at all. Turning on the charger did nothing. No lights turned on showing if it was charging or not. I tried all the basic diagnostic but in vain....

Chosen Solution I have a XJ750 Maxim and the battery drains when I go to start it. I do anything to kill the battery and the is on a charger. It recently started clicking instead of doing nothing. Any advice on what it may be? Battery is dead, That is why the fast clicking from the starter selenoid. (It doesn’t have the power to hold down the internal spring). Put in a new CHARGED battery & it should start....

Chosen Solution Hi my ex phone (jiayu s3 3gb) that now belongs to my brother is stuck on boot loop It is running on the RC4 ROM (5.1) what you recomend me to do reinstal the ROM or is it past the point of that? thanks Jaxon charge your battery ,, do factory reset in recovery mode by pressing power button + volume up dont wipe all data ,, only system you can backup your files in recovery mode if you added SD Card by going to file management finally i advice you to flash 5....

Chosen Solution Hey guys so I have an iPhone 7 I replaced the screen, the tapdic engine, the power connector, and also the battery. I got it to turn on for a second but, when I plug the charger it wont show the battery if its empty and I hit the power button but the phone wont turn on. The possible region for that solution in my experience. 1 - Battery must be low charge,you have to use extra power source to power on and check....

Chosen Solution i want to send e mail kodack retina 3 camera In early 2012, Kodak ceased production of digital cameras, digital video cameras, and digital picture frames. Live chat, email, and phone support are, regrettably, no longer available for these discontinued products. However, you may find user guides, downloads and drivers, and troubleshooting information by visiting their support site at www.kodak.com/go/support. Should you need to set up a repair for your product, visit www....

Chosen Solution My laptop is neither switching on nor displaying anything. I have shown it to a computer repair shop and he told me that there is issue with laptop’s motherboard. So please tell me how to solve this problem. Hi, When you say that it is not displaying anything, does this mean that the charging light does not turn on at all when you first connect the charger to the laptop?...

Chosen Solution Mine is the one with i7 processor 512mb Intel graphics and 1gb dedicated AMD GPU. So here’s what I got so far: -tried that method posted on macrumours: single used then nvram fa4ce28d-b62f-4c99-9cc3-6815686e30f9:gpu-power-prefs=%01%00%00%00 It doesn’t work. Actually most of the time I was unable to even access single user mode for whatever reason. -tried holding power button 15s with partial success: it worked and the laptop got pretty quick but so does the fans that would go crazy loud and wouldn’t go down with fan control as the sensors were disabled....

Chosen Solution It’s 2 long beeps and 3 short beeps, but the computer starts and works just fine. It has been doing it for a couple of weeks, but not every day. It did it again today after about a week without doing it. I just bought this computer in October of 2019. Thanks for any help. Hi, I couldn’t find the beep error codes for your computer. None are listed in the user manual or the hardware manual....

Chosen Solution Lines have started appearing on the screen Anandita S that depends on what kind of lines and what they look like. Horizontal lines are most commonly caused by a bad panel (failed gate drivers) Vertical lines can be TAB errors, T-con board or main board errors. We would need to know what those lines look like and what the exact model of your TV is. Post some pictures with your question Adding images to an existing question

Chosen Solution Hi I went for a run on Sunday and got caught in a rain pour. Couldn’t put my phone away immediately and it got pretty wet. Now part of the touch screen doesn’t work, horizontally, finger wide area at the height of the power button. Anyone know where the water damage indicators are on this phone? I found the battery one. Thanks! Hey Lorenz, For Motorola its only at battery and slots like the simcard or the Microslot...

Chosen Solution My Mac Mini (2014, fusion drive) started to constantly freeze and require hard restarts. Soon after it started having boot problems too. I don’t remember the specifics of what would happen at boot, but ultimately I was only able to boot into safe mode a single time. I haven’t been able to get it to boot since. Currently it powers on (front led turns on), chime sounds, external monitor turns on but screen is blank....

Chosen Solution Hi, in detail this MacBook has been water damaged i have bought it with intent to pull apart for parts but before i did i thought id see if i could get it working. I managed to get the laptop working and clean up the inside and managed to get the whole thing working once i disconnected the battery and powered on through the power supply, now after i turn it on through that i can turn it off and plug the battery back in and turn on with power connected and the battery charges and works from the power it puts out without charge connected....

Chosen Solution Hi everyone I got this 2015 MacBook Pro retina 15 inches. It don’t enter in sleep mode when lid is closed, either with apple menu - -> sleep . it do absolutely nothing. I changed the ssd and put in a new one with a fresh Mojave install, so no software related, but if I run safe mode sleep mode works perfectly (even with a external display connected, so I exclude a gpu problem)....

Chosen Solution Hello all, I am experiencing the black screen issue on my mid 2012 Mac book pro retina. I will attempt to replace the chip myself but am unsure what flux to use? I would use some 63/37 0.015 solder I think. Any suggestions? Thank you! Update (12/12/2018) I have already done all software aspects of fixing it, verbose mode, safe mode, pram reset etc. I called Apple and they walked me through the process of the hardware test, which checked out OK....

Chosen Solution So some of the keys my MacBook Pro recently randomly stopped working and it randomly starts and stops again. But I don’t think simply changing the keyboard is going to work cause I believe the issue is with the logic board. I’m looking at the logic board here and it seems it has a 2.8Ghz processor. My macbook has 2.5Ghz. would this logic board work in my machine? Update (11/05/2020) @danj and here is the snapshot...

Chosen Solution How to reset tv without the remote buttons are locked Joseph Holmes … unfortunately, the factory reset has to be done through the tv. if no onboard buttons are working or non existent, you must use the remote. if no remote or non functional, you can try to download a universal remote on your phone or tablet or buy a universal remote or use one from your cable service....

Chosen Solution Hello everyone! When comes to mounting unrecognized devices(USB, External HD), there are lots of talking around web and I realized the easiest way to mount unrecognized device is by going into Disk Utility(it recognizes everything connected) and reformating the device and after that the OSx recognizes it and it mounts properly and is ready to use. Now…I have Sony DCM photo camera which isn’t recognized by my Mac. What do you think will the above mentioned technique be good or I could mess up something on my photo camera....

Chosen Solution Hi, my B-button on my keyboard only works sometimes. Either it clicks, doesn’t click or clicks twice. I have done some of my own research and concluded that the button always works when clicked anywhere from the bottom left-top left-top right region and the issue only occurs in the center and bottom right parts. First of all, you should check to see if your computer is eligible to receive a new keyboard via Apple’s keyboard replacement program....