Posts

Chosen Solution Hi guys! The Macbook’s trackpad becomes randomly oversensitive all of a sudden. It’s a refurb’d 13" Macbook Pro Retina, Early 2015. The random over sensitivity happens more than ten times within an hour. Whenever the problem occurs, when I touch the trackpad with no pressure at all, it senses it as a click and it will click the trackpad multiple times. The clicking is very fast - it sounds like a sped-up woodpecker pecking on wood....

Chosen Solution My rMBP stopped working out of sudden when one day I logged it out and tried to come back in. It didn’t even charge and no lights anywhere in the system, no fans or anything going on. Checked with different charger, still no positive signs. One day when I was just randomly pressing keys it came back alive, it charged and everything normal and then again when I shut it down and next time when I tried to open it, same problem back again....

Chosen Solution Good day, I have a Mac Book pro that i upgraded and after the upgrade, when the laptop is turned on it chimes but then stays on a white screen. Also sometimes it does not even turn on. Even though the magsafe is green and is connected and the white light to the bottom just flashes. Any idea of what can be this issue? This is usually caused by the hard drive or hard drive/IR cable....

Chosen Solution Hi, I’ve got a very strange problem. Within the last 3 days my MBP killed 3 HDDs. The System works normal, until the Hard Disk Drive makes loud noises and the system freezes. After that it’s impossible to access the HDDs again. All HDDs were built in at the normal place and did work without any problems before. Thanks for your help Vicky Update (26.08.2016) Thanks for your reply....

Chosen Solution I updated the logic board from an EMC 2557 from late 2012 to an EMC 2672 from early 2013. Since they are both A1425 models, I had read they would be compatible. Are they? It’s working fine except my wifi is showing “No Hardware Installed”. I tried resetting NVRAM and SMC to no avail. I can’t boot in recovery mode to reinstall the OS without getting the -1005F error code....

Chosen Solution My washer has no error codes. In the test mode I do the spin test and it passes. If I put in one wet towel it will start to spin but not get above 110rpm as per the tach. When there is no load with the towel, it gets to 1200rpm. if I do a standard spin cycle, it starts to turn in one direction slowly, stop, starts to drain and reverses....

Chosen Solution I have inherited an old MBP 15” from a friend. It seems to be a late 2008 / early 2009 Unibody model: model number and serial number on the bottom are worn out and aren’t readable anymore, but it has a full-width latch door on the bottom of the case. The laptop suffered a cat-induced fall, and won’t boot since then. It has no visible damage: no dents, no cracks, no bumps....

Chosen Solution I am missing a surface mount component on my iphone 5s. I’m looking for help identifying the component so I can order/replace. I’ve attached pics to show the area. Any help appreciated. Cory, that is reference designator FL4. It is a 120 ohm 250mA 25% filter coil in a 01005 package. You can go up on the current rating and use something like this If you have a working iPhone 5S Logic Board you can test that same component with some SMD tweezers in auto-detect mode....

Chosen Solution My Samsung exhibit T599 is having no network issue after its screen was changed. Please, what can I do to rectify this problem, thank you. Best Regards. Are you sure all the wires were reconnected properly before you reassembled it? It can be common that a connection wasn’t put back on correctly. It could also be possible you just have to make sure the date and time is set correctly....

Chosen Solution So, I recently bought my Sebring JXI. It’s a V6, and I seem to be having issues with it starting. It will turn over, but not start. I found out that it was not creating a spark, so I replaced the spark plugs and wires. Still won’t work, so I replaced the distributor cap and rotator. Still no spark. So, I tested the fuel pump. It’s working just fine....

Chosen Solution I’ve had my 3DS for a few months now, recently the top screen starts going dark, I can usually wiggle it to get it back, its like the backlight goes out or something. I don’t know if it the device has been dropped, my 3 year old plays with the device quite often so it is possible. Other than that the device works fine. When I started googling similar problems I found some people talking about the flex cable, I guess it can go bad from just opening and closing the screen on certain models....

Chosen Solution I’ve changed the batteries, have both of them fully charged. Changed lenses, changed CF cards and still no luck. No corrosion or any sort. I use the camera canon for photography Because I’m always traveling But my camera lens is not working well You may want to check and replace a fuse on 5D power board (top board on the right size). That fuse could be one of the reasons....

Chosen Solution The leg won’t go up,I’ve tried WD 4,still stuck,tried tapping the arm from the right side,that did not work either. https://www.youtube.com/watch?v=hlfXmN7C… Enjoy the ride. Yes Right kick jamming no bike starting without kick

Chosen Solution Hey, my laptop “HP 650 NOTEBOOK” won’t turn on, everything was working fine, until it turned off, i tried to charge it and it worked, then it turned off completely without any sign, I’ve tried to unplug everything and nothing works, when the ac adapter and the battery are connected the charger port blinks 3 times. I assume the battery is drained, and if so what am I supposed to do?...

Chosen Solution Hello, I have a issue with my Mac I was working on my computer and suddenly shutdown and restart asking me for a password and also a pin # something that I don’t have because I never used or put a password After some trials, I give up and buy a new hard drive I installed , but it didn’t work I receiving a folder with a question mark I already try pressing “C” or Command + C , etc all those keys commands I don’t know what to do a this point can someone please help me Thank You This is the serial number of my Mac: C02JHN2ZDTY3...

Chosen Solution Hello guys, I have a problem with my new mac, after I deleted sleepimage file my Macbook did not want to start after I did a shutdown, so I push and hold power button for 10 seconds and it run, BUT after this I have a problem, because it flashes for one time (in fully charged mode its from green to orange and back to green) - I think it shows me that Mac is resetting nvram or smc for every shutdown I do....

Chosen Solution i have a glaxy grand prime, it switches off automatically and then it stucks at device name, i have to pull my battery to switch it off, i have tried hard reset also and when i reboot my mobile it again stucks at device name, i have also used odin but device says recovery is not seandroid, what should i do I don’t why it’s doing that but I have had it happen before and every once in a while it still does it....

Chosen Solution my Nexus 6p spent about 20 minutes in a light amount of water in a ziplock bag. When I go to turn it off, it shows the charging screen and then the Google screen will pop up. Sometimes it will start the android screen of the start-up, but then it goes black and the red notification light will start blinking. I’ve successfully taken the thing apart, but am not sure where to start now....

Chosen Solution My laptop has completely shut down and when I try to turn it back on I get a screen that says that my a driver needs to be installed. I think it has to do with my hard drive. What do I need to do to get it back on. Download version 9 or 10 of the Intel Management Engine Interface (MEI) Driver. Navigate HP’s Software and Driver Downloads site (http://www8....

Chosen Solution Hello Looking to get a Lenovo C330 boardview software. Can anyone steer me in the right direction. Board number is BM5688 Thanks! Hi, A Boardview file for the motherboard doesn’t seem to be available online but here’s a link to the schematics for the board that may help.