Posts

Chosen Solution My phone was working perfectly fine but then it run out of battery and now the screen won’t work, i can hear it receive messages and when i touch the screen it still vibrates as if it’s working. When i put it on charge the lcd screen works and says charging… so i know the screen isn’t working. PLease help. Try a hard rest to see if that fix’s the screen issue if not, try opening the phone and disconnecting the LCD/digitizer flex cable and reconnect to see if that solve the problem....

Chosen Solution Lost password to BIOs I see the clearcmos pin but can’t make them work Any idea on how to reset password? Lenovo C40-30 aLl in one You can clear the cmos by removing the motherboard battery. There should be a guide here on iFixit that shows you how to do it without much trouble.

Chosen Solution i need to open up Ninja and locate the sensor and bypass, even on a full carafe after 3 seconds it beeps and stops brewing Probably not the sensor. It is probably clogged in the upper part before the spout. I have had 3 of these machines that all did that right after about a year…I finally figured out the problem.

Chosen Solution Hello guys I bought a 2nd hand Samsung galaxy s6 edge off Ebay when I received it I wasn’t happy with the item so i didn’t even switch it on and i opened a return case thought will return it but unfortunately Ebay decided the case in sellers favour then I thought ok I will keep it so I turned it on and see a Samsung activation lock appears on the screen I contacted the seller several times but no reply so I’m left with this activation lock on the device which I can’t even use it because I can’t go further and activate the phone so I’m asking for help if anyone knows any way to sort this out would b much appreciated....

Chosen Solution I lost one of the rubber pads for the magic trackpad. Is there anyplace that i can buy it? Here’s how to do the repair: Magic Trackpad Rubber Replacement/Reinsertion Here’s some feet that might work: http://www.resourcesforlife.com/docs/ite… UPDATE 7/19/17 The feet are now available: http://www.ebay.com/itm/4pcs-set-New-for…

Chosen Solution I have the dim light problem with my Macbook pro. The laptop received liquid spill a while ago (half a year) but it seem to work just fine until last week, when I tried to plug in the charger and all of a sudden the laptop shut down and I haven’t been able to boot it. I have tried: Using another charger (still get the dim light) Resetting the SMC Replacing the battery Removing battery from motherboard and plug charger to see if the laptop reboots (it didn’t)....

Chosen Solution Hello, all. I have recently swapped out my hard-drive to an SSD. The first day it ran like an absolute dream but since then it has been awful. Sometimes when powering it on it comes up with the circle with a line through it (I believe this indicates and OS issue?). I used internet recovery initially and then upgraded to High Sierra. If i get it past the circle with a line through it it runs extremely slow and cannot actually perform any tasks....

Chosen Solution Hello, Ive got a MacBook Pro 15 (late 2013) i’ve been experiencing a Wake-Sleep in EFI error every time my Mac went standby closing the lid. In other words after 1 min (approx.) it was rebooting on its own. Recently I have changed the battery because the old one was 900 cycles old. It was doing great even tho I still didn’t manage to fix the Wake-Sleep problem. However one day it decided to die....

Chosen Solution Ok, folks here’s the deal. I desperately need a new(er) mac. I can no longer update my OS. The problem is I had upgraded my iMac to a 4T hard drive and I am using a lot of that space. The new iMacs don’t have options for a large HD unless you want to spend 6 grand. So, I need to know what of these options I have: Transfer my current drive into a 2019 iMac (I can find compatibly info)?...

Chosen Solution Accidentally caught rubber spatula in mixer blades while making a batter, a spark burst from the seam where I assume the motor is on the top of the machine, and now it won’t turn on. It’s a Sunbeam Electronic Mixmaster, Model No. 01401, Service No. 1-40CD, Listed 423A. Pretty sure I killed the motor, but can it be fixed? When an electric motor gets locked, it gets hot really fast....

Chosen Solution Hello everyone. I have obtained a control board to convert a LCD panel into a monitor. It has a 4 Pin connector for a speaker out line. I have external speakers which require a 3.5mm line in, optical or RCA cables. I have no idea how I would connect the two. I have searched online but came up with no results for this. Here is a picture of the connector, it is circled in red....

Chosen Solution Hi, Recently carried out a full chassis / rear case replacement on an iPhone 5C. Everything went fine except the mute slider toggle - it just goes up and down aimlessly and doesn’t have that ‘click’ into position which I know it should have. Also, when I slide it, the phone itself doesn’t register its been put on / taken off mute. I assume its not connected but I have checked and the black box appears to be connected to the slider notch....

Chosen Solution ok so my 3.5mm jack wire broke right where the wire goes into the jack I cut it off and the wires are white with copper around it a blue wire wrapped around string and a red around string as well as a green one.. my question is I have a good jack I cut off my old Recon 70’s and only matching wires are the white with copper around it the other wires seem to look like copper as well but with a clear sheathing over them please any help would be appreciated greatly...

Chosen Solution Hi, I bought a 3ds second hand, and it was working fine, reading all cards, but recently it almost exclusively reads normal ds cards, but not all of my 3ds cards. Sometimes it says there is no game in the game slot, even when I’ve inserted the card, and sometimes it shows that the game card is inserted, but it says that the game cannot be read. I took it to a local gaming store, and the person working there says it might be the console’s memory, but even he wasn’t to sure with that diagnosis....

Chosen Solution I don’t know what happened but my back camera is just a black screen now. My front camera works perfectly. Every time I go to the back camera it’s just black but it shows that I can still zoom in and out. The flash doesn’t work either even out the camera. You might need to replace the camera. This is not hard if you know what you are doing....

Chosen Solution hello i replaced my charging port on my samsung galaxy s4 and all of a sudden the back and menu button do not work at all check your Menu button cable connect your charging port yes/no….. if connected you need change agin charging port…. hope you solved ….

Chosen Solution When my camera freezes up, I have to pop out the battery, reinstall and it will work for a few more shots. Not too convenient on holidays. Currently having this issue with my Lumix DMC-GF6, too.

Chosen Solution I bought this 2004 Platz with a replaced 1sz engine. (I don’t know why the engine was replaced). I have been having trouble with it over sluggish acceleration, shaking and even stalling at stop lights. Even now the issue is worse because the car can not accelerated however much I press the gas pedal. I had it diagnosed for faulty oxygen sensor, faulty mass airflow sensor and faulty throttle position sensor....

Chosen Solution I was playing with my gba sp and the charger broke. And the head of the charger came off is there a possible way of fixing it probably the most cost effective and safest method is to buy a new one.

Chosen Solution Can the charging port on a PS Vita be replaced without changing the entire motherboard? Jerry, only if you find a proper replacement. you can de-solder the old one and resolder a new one. Problem will be to find a replacement. YES you can, I did i brought a vita charging dock and brang that to ubreakitifixit …. they soldered that new piece on …. the new piece coming from the dock has a board attached to the pins and bascially there is NO LOOSE PINS THAT GET SCREWED UP OR DAMAGED …....