Chosen Solution My SD card keeps on auto removing due to multiple unintended drops of my Zenfone 6. I tried to see what’s in it and what I can do to fix it, but this happened._ http://imgur.com/a/8vsJM So I did some researched and found out that I should replace the whole thing because apparently those dual sim slots don’t also work, I have to keep on reinserting every time the SD card or Sim goes auto removal....
Chosen Solution The flash at the back never turns off, it barely affects the battery however it is very annoying, the only time it turns off is when the phone is powered off, however when I click the flash button on my phone it only gets brighter but doesn’t turn off, what should I do One thing to check is that one of many flashlight apps isn’t the culprit. Did you perhaps use one accidentally or a-purpose then forget to turn it off?...
Chosen Solution My Samsung Gear S3 Frontier watch is dead, when put on charger red light normally lit, after about 1.5 minute it start flashing, i tried to remove it and re-put it many many time but no success any advise or description of what it might be the cause. Thanks for help.. Jeff i found the solution for this case but it is hard, it worked for me perfect as i’m an electronics engineer the solution is to open the back cover of the watch and solder 4 wires usb cable inside and connect it to any USB charger it will open in seconds again if you are not qualified for this, look for someone can do it for you since then i never let my watch die again look at this video this picture
Chosen Solution So my phone suddenly stopped detecting the wifi in my room and it’s weird because my iPad and laptop are connected to it and it working perfectly. Also, my phone DOES connect to any other wifi in my house or anywhere else. I tried turning the phone off and on, restarting it and moving around and nothing works and I’m GOING CRAZY. Please help me! My be your router, did you go to another wifi location and does the phone hook to wifi there....
Chosen Solution i turned off my ipod for 3 seconds then holded the home and lock for 10 seconds thena red music note then itunes under it then a arrow pointing up and then a charger and idk what to do You put it in dfu mode
Chosen Solution Hi, I am a beginner at this tech stuff, like only 13. (So please be clear).I just took out the hard drive of my imac, and put in an ssd. I am trying to get software on it.So when I go to download it. It says pick a drive to install on. Well mine does not show up. But it does show up in disk utility. Can someone pls help....
Chosen Solution Hello, I mistakenly wash my MacBook Pro 13 mid 2012 motherboard with petrol instead of compressed air. Now the mac doesn’t boot. Please what can I do? Time to find someone with a large enough ultrasonic to hold your board. You want to use a variable frequency unit as it will be able to more effectively remove the petrol. You’ll need to use a solvent which can cleanse the petrol which is non flammable and don’t have dangerous vapors in the ultrasonic....
Chosen Solution i can’t boot into hboot or fastboot i have a permanent black screen pressing and holding any button does nothing and that happend because i tried to flash a rom in a zip file (which turned out to be corrupted) from my sdcard please help and thanks in advance @george123 , George, I do not own this device, did a search on your problem and found the link below that may relate to your issue, for you to check out....
Chosen Solution the key covers popped off 2 keys of my laptop. doesn’t seem to be anyway to put them back on. has anyone encountered this problem before and been able to fix it? thanks very much It’s 100% possible to fix a typical iBook keyboard…I put keyboards I’ve repaired on every iBook I sell. The trick is that when a key comes off, typically the “scissor mechanism” underneath, which is made of two pieces of plastic, comes apart as well....
Chosen Solution I spilt a glass of water around my laptop yesterday and obviously some of it splashed. Picked it up asap and unplugged everything in it, dried the area and it was still working. Turned it off 10 minutes later and left it overnight. Just now, I’ve turned it on, it was working for 10 minutes and now has cut out without turning back on, Any ideas? First problem, was you continued to use it after water was spilt on it....
Chosen Solution `` ``Continued from my last post (Space between inner tub and outer tub), now I have heavily damaged towels, shredded and holed. The towels were probably worn and thin, but still….. what gives? Is this something entirely different? Please share your experience! You might be running the washer on too high of a spin cycle relative to the durability of the material in the towel. Cotton clothes should not be spun higher than 600 revolutions per minute (sheets and towels can use a higher spin at 1400 revolutions per minute)....
Chosen Solution Hello, I actually have a Canon PowerShot ELPH 360 and after an accidental drop, the lens will not always go in or out….how can I get this fixed? Can I fix it myself?? Thank you for any help Your lens assembly slides within the two or three helical tubes that screw in and out to extend the Lens forward. Either the tubes have jumped their slots or the lens assembly has....
Chosen Solution After removing the hot food and closing the door on my Kenmore microwave the light turns on and the turntable revolves without setting any of the controls. Some times it does this upon opening the door. I have to open and close the door several times to get it to stop. It does not appear to be heating when doing this. The cancel button will not stop it. This is an intermittent problem and does this about10-20% of the time....
Chosen Solution Hey I have an old Sony KDL-52NX800 and it has lines across the screen and looks pixelated. Aside from it being old I don’t really know what could be wrong. Can anyone help me out? I attached a picture to hopefully give more info ok here’s the t con. It doesn’t seem to be damaged anywhere. John Hricz that looks like either a bad LCD driver board (part of the panel) or a bad T-con, main board....
Chosen Solution Hello, Recently my retina display started flickering. It happening randomly, seems like the display is not synchronizing. Usually after 2 minutes after the startup. This issue is only present on the Retina display, on external monitor, everything is fine. I want to point out that I didn’t drop or hit the MacBook, this suddenly happened when I was web browsing. I did already try first to unplug LVDS cable and plug it back, but it didn’t work....
Chosen Solution Hi, So I literally made this account just to ask this question. I bought the 2019 MacBook Pro 13” literally 3 (THREE) DAYS AGO lol I did open it over 90 degrees once during the day and in the evening the backlight stuff (dark shadows) started getting bigger in the screen. I then closed the laptop and opened it again and it was gone. When I googled this topic, I found out that usually after the backlight thingies shut down, the whole screen shuts down after that....
Chosen Solution I have been chasing a charging issue since I got this macbook pro. I was given a brand new charger 60w with the purchase and have replaced the battery and dc board as well as look for any signs of damage or burnt componets with no luck. I even bought an 85w charger after reading a forum stating 60w can run the macbook but can’t charge it. I have reset the smc and pram or nvram....
Chosen Solution Well to start off, I spill soda on the keyboard. My first reaction was to pull the charger and a quick shut down. Now I’ve disassemble the whole book to pieces and cleaned everything out. I then reassemble the book back after a week of drying, and everything worked fine, you name it bluetooth, airport, superdrive, usb’s, ethernet, etc,. I didn’t think to check the charger until I was at 50% of charge....
Chosen Solution i charged it and it worked fine the next day everything was fine but the mic wouldnt pic up any volume how do i fix them? how do i replace everything on it because at some point i will have to change everything on it out Sadly these are not really repairable. Its designed as a throwaway. Apple doesn’t offer any parts for them so you would need to find a second one to steal parts from and the you end up splicing the cords which weakens the headset....
Chosen Solution Hi guys, Does anyone know a part number for a replacement part for the thunderbolt / mini-display port on the A1644 Macbook air? And, if possible a place to buy the part? In the schematics floating around online, the part is called J9400, with what appears to be manufacturer part number MDP-J11 F-RT-TH. But that doesn’t get me any closer. Thank you! Sadly the connector is part of the main logic board....
