Posts

Chosen Solution Hello to all, my macbook does not start, I think it is a problem of capacitors, only the hard disk starts but does not emit any sound, the display remains black, the fans do not start and neither does the DVD player. has anyone had the same problem? do you have any solution? Lets pop off the bottom cover MacBook Pro 15" Unibody Mid 2012 Lower Case Replacement Do you seen any corrosion damage or staining?...

Chosen Solution My Laptop is old and running slow, but does function. However, It will not shut down, log out, or restart when chosen from the Apple menu. I can hard restart and it boots properly. I have reset my PRAM. Please help. It is very troublesome to hard reset such an old computer, and very difficult to update settings and apps. What version of macOS are you running on this model?...

Chosen Solution I recently replaced the ice maker in my Maytag refrigerator. Fridge has French doors with freezer on the bottom and Ice maker on the top in the refrigerator portion. Since replacing we have been getting very low amounts of water in the ice maker. Running the water fill test did not fill the ice maker. In trying to check the duel inlet valve, I noticed the water runs through the fill tube when the cover is removed....

Chosen Solution So it beeps. my friend said it might be a chip issue. So how do I repair that? Or can you recommend someone I can send it to for it to be repaired? Is it like a 3 pattern beep where in between the beeps is about half a second each time? If yes, the fault is usually either bad ram slot or faulty ram. To test for a bad ram slot I only put one ram stuck in....

Chosen Solution I purchased a replacement motherboard for a Lenovo Ideapad 330-15IKB (Part No. IF245-140-1). Although the replacement board was not identical, it fit so I installed it and it boots up. The problem is that there is no connector on the board to plug in the cooling fan as there was on the old board. There is a spot in the same place on both boards designated JFAN1 but on the old board there is a connector soldered to the board while on the new one there is not....

Chosen Solution My yard machine 14.5 HP B&S will not start I cleaned the crab and that didn’t work then I replaced the carb and it worked for a little bit (15m) then it quit starting I tried l cleaning the tank and that didn’t help either. It is getting gas to the carb and when it does start it runs great no choke needed. I am completely clueless on it any ideas?...

Chosen Solution When we on it shows Balck screen did u give camera permission Hi, I also have this problem. When I opened it, I found out that the front camera ribbon cable is cut. The front camera and the back camera uses the same board attachment. Since, I have been using this phone for almost 4 years. I bought another andriod phone other then fixing it. Hope this helps...

Chosen Solution no matter how long the device is left to charge it will not turn on. the led flashes to indicate charging. the device has been updated to the newest software. @niall.lawrence… it sounds like the battery may have lost its capacity to store energy. i say this as i am taking into consideration that it shows that it is charging via the indicator light. with that said, it is very possible that even though it shows the indicator that it is charging, it is not actually receiving any voltage....

Chosen Solution I deleted “other volumes” with “view all” options, and now my internal ssd is not displayedHi! I recently wanted to format my old MacBook air, and reinstall OS sierra. During recovery mode, in disk utility, I saw that after formatting Macintosh HD, there were like 40gb in use, by “other volumes”. I thought that they were other users profile (I had 3 users active in the macbook) so I wanted to delete those as well....

Chosen Solution So i just got my iPhone 8 Screen replaced and now it’s hard to type on the screen, and when i type it starts glitching. How can i fix this? Please help! It’s most likely a bad screen. Have you ensured if any gold exposed contacts on the ribbon flex are covered with black / yellow kapton tape (sticky tape will do too)? These can short out against the metal plate that goes behind the screen....

Chosen Solution why wont my washer spin or drain Belt, Water Pump If the washer won’t drain the pump belt might have broken or might have worn out. Check the belt and replace if it shows signs of excessive wear. Drain Pump If the washer won’t drain water the drain pump might be defective. It’s also common for a small sock or other article of clothing to get caught in the drain pump or in the drain hose....

Chosen Solution Need help in dissembling my laptop to clean, probably heat sink area and fan. Can you guide me through this. I have DELL XPS 14 L401X, 5 years old laptop. here some instructions to cleaning the dell fan https://www.youtube.com/watch?v=nmn3C4qg… and the Servive manual xpsl401x.pdf

Chosen Solution So my Macbook Pro touchbar was working fine until two days ago and suddenly the screen turned dark blue. I tried all of the troubleshooting options (smc reset, nvram, safe mode) and still nothing showed up. The next morning I connected it to my external monitor and it was displaying everything on the external monitor but still nothing on the mac itself. Luckily I backed up everything while the external monitor was working....

Chosen Solution imac 21.5 mid 2011 I was instaling SSD drive into my mac and my LCD start flickering since than. I also replaced thermal paste on CPU and graphic card and add some more RAM during this upgrade. I tried to replace ram and cpu (I have a spare one) led driver board (doesnt help) and v sync cable (was damaged so I order new one- does not help at all)....

Chosen Solution So - inherited a LG 50UH5530-UB. Symptoms, no picture, no sound, no backlight. When plugged in, and turned on, will get a very brief (less than a second) flash of the LED and the LG logo on the screen, and then completely nothing. Red Standby light will flash 2-3 times. If I try to turn it on again, i don’t get the LED Flash and logo, but I do get the three blinks on the standby light....

Chosen Solution How do I activate my Nextbook since I lost the receipt and the activation code with it and I don’t have the box anymore You might have to contact the company to attempt to receive the code they may be able to find your transaction and could retrieve the key but I am not certain

Chosen Solution Hi everyone, I have 2012 13” MacBook Pro I broke the LCD display but Apple doesn’t support this model any more I found local online a company NiwTech where they offer to fix the laptop for me and after they fix it they give me back the old part. But wasn’t Apple it was LG brand when I went back to them I said this is not my part my LCD should be Apple they said Apple never had an LCD brand by them self they use different brands....

Chosen Solution How ca I find the model of my MacBook Pro? I mean A1260 or similar? it’s written on the back of your MacBook, top center near the FCC and CE logo. Usually like this: Designed in Apple California. Assembled in China Model Number: A1260 You can see the model number under the product and on the About This Mac tab

Chosen Solution Although the lid is closed and the magnet attached to the lid is intact, the door open error message (dE) is displayed and the machine (LG fuzzy logic model no. T6515TDPT01) stops working after taking two /three turns in wash mode. I seek help from you guys to fix the problem. Thanks Might be the magnet, usually the magnet pushes this switch the shows the door is closed. Hard to explain....

Chosen Solution Where is the location of the magnets and its Sensor for the sleep mode? My DS wont boot anymore , Black Screen After powering Up and I tried everything ( Wifi, checked cables ) and my last idea is that something is wrong with the magnets so it is forced to sleep. Hi! The magnets are located in the area near the power button/ underneath the B button....