Posts

Chosen Solution Macbook air loads to desktop then after a very short while cuts to black screen and needs to be switched on again. Unfortunately it doesn’t reload again. Loading screen when unplugged takes forever sometimes makes it to desktop sometimes not. When plugged into wall fine works a treat. Is it battery or logic board or both. Have reset everything and it still keeps doing the same problem over and over again, until plugged into charger....

Chosen Solution my keurig k40 is leaking water from the bottom There are several possible causes. The easiest to check and fix is that the holding tank is cracked and leaking. Its also possible that the needle is clogged up with grounds, you can use a paperclip to clean out the needle. It could also be that something is broken inside the which is difficult to diagnose without taking it entirely apart....

Chosen Solution The led on the power supply is red.When I unplug from the back of the xbox it turns orange.Plug it back into the xbox and it turns red. It sounds like the Power Supply has developed a fault. Replacing it with a different Xbox 360 S Power Supply should fix the problem. You can find Microsoft’s guide to this problem here.

Chosen Solution Bulbs have been replaced. Membrane swith for light gives indications on display for “HIGH”, “NIGHT” and “OFF”, but bulbs do not light. I have the same problem Wes - i was looking for part number to just replace this part but dont know where to find it

Chosen Solution needing some help, I replaced the power button flex and screen after the replacement, there was no sound from the loud speaker. I’ve tried replacing the power button again and the loudspeaker it self along with the charging port flex the speaker is connected to. is there anything I can take a look at on the mother board it self? or anything else it might be? Are you sure ur flex cable if ok ?...

Chosen Solution So I got this phone from a friend who happened to break the display. This happened from him accidentally bending the phone. And you can tell by a small kink in the aluminum frame of the phone. Its kinked on the top part of the bottom volume button. Anyway thats the extent of the damage to the phone. So I went and replaced the display and then sealed it back up....

Chosen Solution There’s illuminated bulb at top of refrigerator but no where located to place and insert bulb to light bottom half bins. Update (06/30/2021) Thanks it’s ED5LHEXTDOO - MODEL WHIRLPOOL Hi @gwncity, Bit confused as there doesn’t appear to be any lights at the top of the refrigerator compartment, however there is a light at the top of the freezer compartment Here’s a link that shows where the lights are located in the refrigerator compartment....

Chosen Solution hello, so first the macbook didnt have backlight, i have replaced the fuse and LCD connector because they were corroded, now the screen works perfectly, but the problem is the keyboard and touchpad are not working only the power button is working i can turn the macbook on and off, before i order a keyboard and trackpad i want to be sure its not a motherboard problem, can anyone help?...

Chosen Solution Heat Problem! In MacBook Pro Purchased 2 heatsinks to use as replacements. The replacement heatsink pads are out of alignment with each other by 1-2 degrees with each other. Which means the paste is going to be squeezed out unevenly (Poor heat transfer). Questions. Are the CPU & GPU mounted in the same exact plane? Can the pads be milled to realign them? Are the copper pads solid copper or plated?...

Chosen Solution Hi There, So this issue is about a year old. I spilled coffee on my laptop last year right by the magsafe port and it ran down from there to the other wide and towards the trackpad. It sizzled a bit and then shut down. I cleaned it off and then it worked again when it was plugged in. It now only works when plugged into a wall charger, if i take the cord out it shuts down (just turns right off no actual shutdown process)....

Chosen Solution So I was recently away for about two weeks and I left my laptop and home and did not use it, I left it unplugged on a flat surface for those two week and when I came back and tried to turn it on it acted like it had run out of battery (understandable) but I tried to plug my charger in and the charging light did not turn on and the computer would not power up, I tried to figure out different ways to fix it and one of the times I just plugged it in and it just started charging out of no where, it didn’t seem like it was something I did, just chance and then it power up and started working....

Chosen Solution sometimes says put correct size paper in machine Hi, Does it happen when printing from a PC or only when making copies using the printer’s control panel? If it only happens when making copies, then does it only happen when using the ADF, the platen glass or both? If it only occurs when using the Automatic Document Feeder (ADF) and not when making a copy via the platen glass, the issue is commonly due to small marks or debris on the scanning glass area that lines up underneath the ADF roller....

Chosen Solution My main camera suddenly turns blurry all the time. I tried to fix everything on setting or even recovery my phone it is still not fixed. I do not know what happens, and how to fix it. Does anyone know? Help me, please! Thanks so much! you probaly might want to clean it or add a lens! It would be useful if you could share a sample picture, something with a bit of a distance....

Chosen Solution My mass air flow sensor keeps getting wet and I can not figure out why. I thought it was because it was located on the bottom of the car but I dont think that is the case. Im wondering if it may have to do with the red and yellow round piece near it any help would be appreicated. Update (01/22/2017) Your MAF sensor is getting wet because there is water in the intake box....

Chosen Solution Hey Everyone, my mid-2012 MBP A1278 refuses to start up with the power button. I can only boot it by opening it up, disconnecting the battery, reconnecting the battery, then reattaching the MagSafe which automatically boots it ( put Catalina on it). Magsafe power adapter seems to work fine, bright orange when charging, bright green when charged. Also, keyboard backlight does not seem to be working. Here’s what I’ve tried so far: hold down button for 10 secTried a different chargerBoot in safe mode (but then what do you do?...

Chosen Solution My Samsung J3 5 media volume only plays through headphones and when I make a call it only works on loudspeaker. Also when I turn phone on it seems to be stuck in headphone mode even when they’re not in. @westernstacey sounds like a stuck headphone jack. Insert your headphones and remove them a few times in rapid succession. It is possible that this will unstuck the jack. If it does not you have to consider replacing the headphone jack....

Chosen Solution My ABS and Traction Control light are always on, how can I fix this and are they absolutely essential or can I just turn them off. It will still pass NY state inspection with them on @dragonofaz , Matthew, Check all fuses and relays. Could be faulty wheel bearing/bad/loose wires/plug to ABS sensor or could be faulty ABS sensor, ABS pump motor faulty, EBCM faulty, etc. To help diagnose the issue better, have the vehicle scanned for error/diagnostic codes which may pin point the issue....

Chosen Solution My 2001 Frontier AC unit runs hot air for half an hour before cold air comes out, and when it does the pressure is good too. @nassaubay could be a bad compressor etc. Start off with making sure you have enough refrigerant. With AC’s it is hard to make a determination since it requires the proper gauges and testing equipment to do so. Consider having it checked (diagnosed)by a AC shop....

Chosen Solution Hi guys, any idea what could be the culprit? Laptop is dead, no lights come up, nothing. I’ve dismantled the whole lot, checked the voltage getting to mobo - at the charger I’m getting 19V, at the endpoint of power-jack - same. Was 100% sure that the mobo is fried out - bought a new one, no joy again. Even with the fans connected to it, they don’t spin....

Chosen Solution What should I do if my battery is not holding charge like it should or it is not charging at all? Drain the battery all the way and then plug in the device so that it can charge all the way without using the device during this process. Also try cleaning the plug insert with a cloth or pick to remove any debris or dust that might be blocking the charge....